How to install a wall hung vanity

Following are the procedures for mounting a wall-hung vanity:

Find the wall studs where you intend to put the vanity. The support-giving wooden beams inside the wall are known as studs. To make sure the vanity is firmly fastened, you must screw it into the studs.

On the wall, measure and mark the desired vanity height.

Mark the holes for the screws with a pencil while you hold the vanity mounting plate up against the wall at the designated height.

Using a drill and a drill bit that is slightly smaller than the screws, pre-drill holes into the designated locations.

With the mounting plate pressed up against the wall, fasten the screws holding it to the wall with a screwdriver.

Make sure the vanity is firmly in place before sliding it onto the mounting plate.

Using a screwdriver or a tool, tighten any screws or bolts holding the vanity to the mounting plate.

As directed by the manufacturer, install the sink and faucet.

In accordance with the manufacturer's recommendations and regional plumbing regulations, connect the vanity to the water supply and drain.

When drilling and screwing into the wall, it's crucial to follow the manufacturer's recommendations for your particular vanity and to proceed with caution. It is recommended to employ a professional to instal the vanity if you are unclear of how to do it safely.